meta data for this page
DC Distributor 3pin RS
The product is solely and exclusively available for commercial costumers and shall be used by skilled personnel only.
Use the product only for the purpose described in this document. Always follow the valid instructions and system requirements for all equipment involved.
Series of compact voltage distributors with 3pin RS1) sockets. Due to the small size and the many configuration possibilities, the distributors are perfectly suited to be mounted on the camera or to be used in a WCU setup.
All distributors are made of aluminium, black anodised and have a CE marking.
Apart from an LED which indicates the presence and polarity of voltage, the distributors doesn't contain any further electronics, such as overvoltage or over current protection (aka. fuse), reverse polarity protection or similar.
Never connect two voltage sources at the same time!!
In all distributors, the housings of the sockets have an electrical connection to each other in order to protect the electronics of the camera when connecting accessories with HD-SDI interface. This requires the use of shielded cables and avoiding plugs whith plastic housings (e.g. D-Tap).
More information from Arri:
- technical information (ca. 82kB)
- Size “S”: three2) interfaces RS 3pin
- Size “M”: five3) interfaces RS 3pin
- distributors with fixed supply cable have a dedicated input7)
- fixed supply cable with RS connector8)
- different supply cables available
- presence and polarity display of voltage
- S/S an Tally signal is passed throug
- Voltage: 9 - 30 V
- Ampere: 0 - 3 A
- Temperature: -10 - 40°, not condensing
There are two different sizes available, each with a fixed cable or with a detachable, separate supply cable.
The product can be returned to the manufacturer. When disposing of accessories, please observe the relevant manufacturer's instructions.
Accordingly, this product must not be disposed of with household waste. There are the respective country-specific disposal rules that must be observed.